Quick Start Guide
UD19294B-B
-
Model Manufacturer Standard
BS
The figures here are for reference only.
1
Appearance
2
Installation
3.1
Device Wiring (Normal)
USB
1
2
Lower Cover
Base
Screw
3
Turnstile
Upper Cover
4
Screws for
Elevation
Adjustment
Moutning with Bracket
Steps:
15 mm (Suggested)
Width of Reinforcing Board＞125 mm
25 mm (Suggested)
The distance bwteen the turnstile
and the board edge should be no
longer than 10 mm
67 mm
67 mm
80 mm
45°
Use 4 screws (M3 or M4),
Secured by flange nuts
Press 8 rivet water-proof
nut
Model: BS-M6-1
4- 12 mm Soldering Hole
Solder the four holes,
polish the outer surface,
and implement with wire
drawing.
Inner Surface
of Turnsitle
Reinforcing Board
Before you start:
1
.
2
3
4
BTN
Installa�on Environment:
Temperature Measurement Environment:
Wind:
Sweat:
Air Condi�oner (Cool Air):
Air Condi�oner (Heat) or Hea�ng: