User Manual

Figure 6-13 Access Control Parameters
The available parameters descripons are as follows:
Table 6-4 Access Control Parameters Descripons
Parameter Descripon
Terminal Auth. Mode Select the face recognion terminal's authencaon mode. You
can also customize the authencaon mode.
Note
• Biometric
recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
level, use mulple authencaon modes.
• If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode Select the card reader's authencaon mode.
QR code You can use the QR code scanning funcon on the
authencaon interface. The device will upload the informaon
associated with the obtained QR code to the plaorm.
Remote Authencaon When you authencate the permission, the plaorm will control
whether to grant the access or not remotely.
Door Contact You can select Open or Closed according to your actual needs.
By default, it is closed.
Door Locked Time Set the door unlocking duraon. If the door is not opened for
the set me, the door will be locked. Available door locked me
range: 1 to 255 s.
Face Recognion Terminal User Manual
36