User Manual

Table Of Contents
Steps
1. If the
authencaon mode is Card and Face, Password and Face, Card and Password,
authencate any credenal according to the instrucons on the live view page.
Note
The card can be normal IC card, or encrypted card.
If the QR Code Scanning
funcon is enabled, you can put the QR code in front of the device
camera to authencate via QR code.
2. Aer the previous credenal is authencated, connue authencate other credenals.
Note
For detailed informaon about authencang face, see Tips When Collecng/Comparing Face
Picture.
If authencaon succeeded, the prompt "Authencated" will pop up.
6.7.2
Authencate via Single Credenal
Set the user authencaon type before authencaon. For details, see Set Authencaon Mode .
Authencate face, card or QR code.
Face
Face forward at the camera and start
authencaon via face.
Card
Present the card on the card presenng area and start authencaon via card.
Note
The card can be normal IC card, or encrypted card.
QR Code
Put the QR code in front of the device camera to
authencate via QR code.
Note
Authencaon via QR code should be supported by the device.
If authencaon completed, a prompt "Authencated" will pop up.
6.8 System
Sengs
On the System Sengs page, you can set the system basic parameters, the face parameters, and
upgrade the rmware.
Face Recognion Terminal User Manual
31