User Manual

• Output: A face
recognion terminal can connect an external access controller. And the two
devices will transmit the card No. via Wiegand 26 or Wiegand 34.
• Input: A face recognion terminal can connect a Wiegand card reader.
5. Tap
to save the network parameters.
Note
If you change the external device, and aer you save the device parameters, the device will
reboot automacally.
6.4 User Management
On the user management interface, you can add, edit, delete and search the user.
6.4.1 Add Administrator
The administrator can login the device backend and congure the device parameters.
Steps
1. Long tap on the inial page and log in the backend.
2. Tap User → + to enter the Add User page.
3. Edit the employee ID.
Note
• The employee ID should be less than 32 characters. And it can be a
combinaon of lower
leers, upper leers, and numbers.
• The employee ID should not be duplicated.
4. Tap the Name eld and input the user name on the so keyboard.
Note
• Numbers, upper case
leers, lower case leers, and special characters are allowed in the user
name.
• Up to 32 characters are allowed in the user name.
5. Oponal: Add a face picture, cards, or password for the administrator.
Note
• For details about adding a face picture, see Add Face Picture .
• For details about adding a card, see Add Card .
• For details about adding a password, see Add Password .
6. Oponal: Set the administrator's authencaon type.
Face Recognion Terminal User Manual
22