User Manual

Table Of Contents
2. Click
to enter the remote conguraon page.
3. Click Other → Supplement Light Parameters to enter the Conguring Supplement Light
Parameters page.
4. Select a supplement light type from the drop-down list.
5. Select a supplement light mode from the drop-down list.
6.
Oponal: Set the supplement light brightness.
7. Click Save to save the sengs.
7.12.16 Set Device No.
Set the device type, community No., building No., oor No., and unit No., and room No.
Click Maintenance and Management → Device to enter the device list.
Click
to enter the remote conguraon page.
Click Other → No. Sengs and Set the device type, community No., building No., oor No., and
unit No., and No.
7.12.17
Congure Video and Audio Parameters
You can set the device camera's image quality, resoluon and other parameters.
Steps
1. Click Maintenance and Management → Device to enter the device list.
2. Click to enter the remote conguraon page.
3. Click Image → Video & Audio to enter the
sengs page.
4. Set the device camera's parameters, including the stream type, the bitrate type, the video
quality, the frame rate, the audio encoding type, the video type, the bitrate, the resoluon, and
the I frame interval.
5. Click Save.
7.12.18
Congure Volume Input or Output
Steps
1. On the Device for Management page, click → Image → Audio Input or Output to enter
Audio Input or Output tab.
2. Move the block to adjust the device input and output volume.
3. Click Save.
7.12.19 Operate Relay
Steps
1. Click Maintenance and Management → Device to enter the device list.
Face Recognion Terminal User Manual
133