User Manual

7.12.7 Network Parameters Sengs
Set device network parameters, including the NIC type, DHCP, and HTTP.
On the Device for Management page, click
→ Network → Network Parameters to enter the
Network Parameters Sengs tab.
NIC Type
Select a NIC type from the drop-down list. You can select either
Self-adapve, 10M, or 100M.
DHCP
If you disable the funcon, you should manually set the device's IPv4 address, IPv4 subnet
mask, IPv4 default gateway, MTU, and port.
If you enable the funcon, the system will automacally assign IPv4 address, IPv4 subnet mask,
IPv4 default gateway for the device.
HTTP
Set the HTTP port, DNS1 server address, and DNS2 server address.
7.12.8 Report Strategy
Sengs
You can set the center group for uploading the log via the EHome protocol.
On the Device for Management page, click
→ Network → Report Strategy to enter the Report
Strategy Sengs tab.
You can set the center group and the system will transfer logs via EHome protocol. Click Save to
save the
sengs.
Center Group
Select a center group from the drop-down list.
Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
7.12.9 Network Center Parameters Sengs
You can set the nofy surveillance center, center's IP address, the port No., the protocol (EHome),
the EHome account user name,etc. to transmit data via EHome protocol.
On the Device for Management page, click
→ Network → Network Center Parameters to enter
the Network Center Parameters Sengs tab.
Select a center from the drop-down list.
Face Recognion Terminal User Manual
129