User Manual

Before the client can receive the event informaon from the device, you need to enable the events
of the resource and arm the device rst. For details, refer to and Enable Receiving Event from
Devices .
7.10.1 Enable Receiving Event from Devices
Before the client soware can receive event nocaons from the device, you need to arm the
device rst.
Steps
1. Click → Tool → Device Arming Control to open Device Arming Control page.
All the added devices appear on this page.
2. In the Auto-Arming column, turn on the switch to enable auto-arming.
Figure 7-11 Arm Device
Aer turned on, the device(s) will be armed. And nocaons about the events triggered by the
armed device(s) will be
automacally sent to the client soware in real-me.
7.10.2 View Real-Time Events
The real-me event informaon received by the client of the connected resources are displayed.
You can check the
real-me event informaon, including event source, event me, priority, etc.
Before You Start
Enable receiving events from devices before the client can receive event from the device, see
Enable Receiving Event from Devices for details.
Steps
1. Click Event Center → Real-me Event to enter the real-me event page and you can view the
real-me events received by the client.
Event Time
For encoding device, event me is the client me when it receives the event. For other
device types, event
me is the me when the event is triggered.
Face Recognion Terminal User Manual
101