User Manual

Before You Start
Before seng the capture parameters, you should set the saving path rst to dene where the
captured pictures are saved. For details, refer to Set Picture Storage in the user manual of the
client
soware.
Steps
Note
This funcon should be supported by the device
1. Enter the Access Control module.
2. On the
navigaon bar on the le, enter Advanced Funcon → More Parameters → Capture .
3. Select an access control device in the device list and select Manual Capture.
4. Select the resoluon of the captured pictures from the drop-down list.
5. Select the picture quality as High, Medium, or Low. The higher the picture quality is, the larger
size the picture will be.
6. Click Save.
Set Parameters for Face
Recognion Terminal
For face recognion terminal, you can set its parameters including face picture database, etc.
Steps
Note
This funcon should be supported by the device.
1. Enter the Access Control module.
2. On the
navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click Face Recognion Terminal.
4. Set the parameters.
Note
These parameters displayed vary according to dierent device models.
Algorithm
Select Deep Learning as the face picture database.
Save Authencang Face Picture
If enabled, the captured face picture when authencang will be saved on the device.
ECO Mode
Aer enabling the ECO mode, the device can authencate faces in the low light or dark
environment. And you can set he ECO mode threshold, ECO mode (1:N), and ECO mode (1:1).
ECO Mode (1:1)
Face Recognion Terminal User Manual
92