User Manual

6. Click OK in the dialog to save the
selecons.
7. Click Save in the An-Passback Sengs page to save the sengs and take eect.
Example
Set Card Swiping Path
If you select Reader In_01 as the beginning, and select Reader In_02, Reader Out_04 as the linked
card readers. Then you can only get through the access control point by swiping the card in the
order as Reader In_01, Reader In_02 and Reader Out_04.
7.7.7 Congure Device Parameters
Aer adding the access control device, you can set its parameters such as network parameters.
Set
Mulple NIC Parameters
If the device supports mulple network interfaces, you can set the network parameters of these
NICs via the client, such as IP address, MAC address, port number, etc.
Steps
Note
This funcon should be supported by the device.
1. Enter the Access Control module.
2. On the
navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and click NIC to enter Mulple NIC Sengs
page.
4. Select an NIC you want to congure from the drop-down list.
5. Set its network parameters such as IP address, default gateway, subnet mask, etc.
MAC Address
A media access control address (MAC address) is a unique
idener assigned to the network
interface for
communicaons on the physical network segment.
MTU
The maximum transmission unit (MTU) of the network interface.
6. Click Save.
Set Network Parameters
Aer
adding the access control device, you can set the device log uploading mode, and create ISUP
account via wired network.
Face Recognion Terminal User Manual
89