User Manual

Note
Up to 64 devices with an-passing back funcon can be added.
7. In the Card Reader area, check the checkboxes in the Enable
An-passing Back column to select
the entrance card reader and the exit card reader.
Note
Up to one entrance carder and one exit card reader should be checked.
8. Click Save.
Congure Entrance/Exit An-Passback Based on Network
You can set the entrance card reader and the exit card reader only for entering and exing, without
seng the rst card reader and the card readers aerwards. It will authencate the an-passing
back according to the entrance and exit informaon on the card reader.
Perform this task if you need to congure entrance/exit an-passing back and judge the an-
passing back according to the entrance and exit informaon stored on the card reader.
Steps
1. Click Access Control → Advanced Funcon → Cross-Controller An-passing Back to enter the
cross-controller
an-passing back conguraon page.
2. Check Enable Cross-Controller An-passing Back to enable the funcon.
3. Select Based on Network as the an-passing back mode.
4. Select Entrance/Exit An-passing Back as the rule.
5. Select a server in the drop-down list for judging the
an-passing back.
Note
• You can click Delete Card Swiping Record and select the card in the pop-up window to delete
the card swiping
informaon in all devices.
• Up to 5000 cards' swiping records can be stored in the selected server.
6.
Click Select Access Controller to select a device for an-passing back.
Note
Up to 64 devices with an-passing back funcon can be added.
7. In the Card Reader area, check the checkboxes in the Enable An-passing Back column to select
the entrance card reader and the exit card reader.
Note
Up to one entrance carder and one exit card reader should be checked.
8. Click Save.
Access Controller User Manual
86