User Manual

Steps
Note
Either the an-passing back or mul-door interlocking funcon can be congured for an access
control device at the same me. For the conguraon of mul-door interlocking, refer to
Congure Mul-door Interlocking .
1. Click Access Control → Advanced
Funcon → An-Passback to enter the an-passing back
conguraon page.
2.
Select an access control device in the list.
3. Select a card reader as the beginning of the path in the First Card Reader eld.
4. Click the text eld of the selected rst card reader in the Card Reader Aerward column to
open Select Card Reader dialog.
5. Select the
aerward card readers for the rst card reader.
Note
Up to four aerward card readers can be added for one card reader.
6. Click OK in the dialog to save the selecons.
7. Click Save at the upper-right corner of An-Passback page to save the sengs and take eect.
Note
Super credenals, such as super card, super password, super ngerprint, and so on, have the
privilege of not following the an-passback rules.
Example
Set Card Swiping Path
If you select Reader In_01 as the beginning, and select Reader In_02, Reader Out_04 as the linked
card readers. Then you can only get through the access control point by swiping the card in the
order as Reader In_01, Reader In_02 and Reader Out_04.
Congure
Cross-Controller An-passing Back
You can set an-passing back for card readers in mulple access control devices. You should swipe
the card according to the congured swiping card route. And only one person could pass the access
control point
aer swiping the card.
Note
It should be supported by the device.
Access Controller User Manual
82