User Manual

3. Select the
rst card mode as Remain Open with First Card, Disable Remain Open with First
Card, or First Card Authorizaon from the drop-down list for each access control point of the
selected device.
Remain Open with First Card
The door remains open for the congured me duraon aer the rst card swiping unl the
remain open duraon ends. If you select this mode, you should set the remain open
duraon.
Note
The remain open duraon should be between 0 and 1440 minutes. By default, the remain
open duraon is 10 minutes.
Disable Remain Open with First Card
Disable the funcon of remaining open with rst card.
First Card Authorizaon
All authencaons (except for the authencaons of super card, super password, super
ngerprint, duress card, duress code, and duress ngerprint) are allowed only aer the rst
card authorizaon.
Note
The First Card Authorizaon is eecve only on the current day. The authorizaon will be
expired aer 24:00 on the current day.
Note
You can swipe the rst card again to disable the rst card mode.
4. Click Add on the First Card List panel.
5. Select a card in the list and click OK to add the selected card as the rst card of the doors.
The added
rst card will list on the First Card List panel.
6. Oponal: Select a rst card from the list and click Delete to remove the card from the rst card
list.
7. Click Save.
Congure
An-Passback
You can set to only pass the access control point according to the specied path and only one
person could pass the access control point aer swiping the card.
Before You Start
Enable the an-passing back funcon of the access control device.
Perform this task when you want to congure the an-passing back for the access control device.
Access Controller User Manual
81