User Manual

Note
You can check Oine Authencaon to enable the super password authencaon when
the access control device is disconnected with the client.
Local Authencaon and Super Password
Authencaon by the access control device and by the super password.
4) Select the added card group in the
le list below and click to add the selected card group
to the right list as the authencaon group.
5) Oponal: Click or to set the card swiping order.
6) Click the added authencaon group in the right list to set card swiping mes.
Note
• The card swiping
mes should be larger than 0 and smaller than the added card quanty
in the card group.
• The maximum value of card swiping mes is 16.
7) Click OK.
Note
• For each access control point (door), up to four
authencaon groups can be added.
• For the authencaon group of which authencaon type is Local Authencaon, up to 8
card groups can be added to the authencaon group.
• For the
authencaon group of which authencaon type is Local Authencaon and Super
Password or Local Authencaon and Remotely Open Door, up to 7 card groups can be
added to the
authencaon group.
7. Click Save.
Congure
Opening Door with First Card
You can set mulple rst cards for one access control point. Aer the rst card swiping, it allows
mulple persons access the door or other authencaon acons.
Before You Start
Set the card permission and apply the permission seng to the access control device. For details,
refer to Assign Permission to Person .
Perform this task when you want to
congure opening door with rst card.
Steps
1. Click Access Control → Advanced Funcon → Open Door with First Card to enter the Open
Door with First Card page.
2. Select an access control device in the list of Controller List panel.
Access Controller User Manual
80