User Manual

Congure Card Reader Parameters
Aer adding the access control device, you can congure its card reader parameters.
Perform this task when you want to
congure card reader parameters for the access control
device.
Steps
1. Click Access Control → Advanced
Funcon → Access Control Parameters to enter Parameter
Sengs page.
2. Select an access controller and click to show the card readers of the selected access
controller.
3. Select a card reader to show its parameters on the right.
4. Edit the card reader parameters.
Note
The displayed parameters may vary for dierent access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
Nickname
Edit the card reader name as desired.
Enable Card Reader
Select Yes to enable the card reader for card swiping.
OK LED Polarity/Error LED Polarity/Buzzer Polarity
Set OK LED Polarity/Error LED Polarity/Buzzer LED Polarity of main board according to the
card reader parameters. Generally, adopts the default
sengs.
Minimum Card Swiping Interval
If the interval between card swiping of the same card is less than the set value, the card
swiping is invalid. You can set it as 0 to 255.
Max. Interval When Inpung Password
When you inpung the password on the card reader, if the interval between pressing two
digits is larger than the set value, the digits you pressed before will be cleared
automacally.
Enable Failed Aempts Limit of Card Reading
Enable to report alarm when the card reading aempts reach the set value.
Max. Times of Card Swiping Failure
Set the max. failure aempts of reading card.
Enable Tampering Detecon
Enable the an-tamper detecon for the card reader.
Detect When Card Reader is Oine for
Access Controller User Manual
75