User Manual

Note
Input the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Person's Basic Informaon.
3. Click Credenal → Fingerprint tab to enter the card credenal sengs page.
4. Select the
collecon mode as Local Collecon.
5. Connect the
ngerprint recorder to the PC and set its parameters.
1) Click Set Fingerprint Machine to open the
seng ngerprint machine window.
2) Select the device type.
Note
Currently, the supported ngerprint recorder types include DS-K1F800-F, DS-K1F300-F, DS-
K1F810-F, and DS-K1F820-F.
3) Oponal: For ngerprint recorder type DS-K1F800-F, you can set the serial port number,
baud rate, and overme parameters of the ngerprint recorder.
Note
• The serial port number should correspond to the serial port number of PC.
• The baud rate should be set according to the external
ngerprint card reader. The default
value is 19200.
• Timeout
aer eld refers to the valid ngerprint collecng me. If the user does not input
a ngerprint or inputs a ngerprint unsuccessfully, the device will indicate that the
ngerprint collecon is over.
4) Click Save.
6. Collect the ngerprint.
1) Click Start.
2) Select a
ngerprint on the hand picture to start collecng.
3) Li and rest the corresponding ngerprint on the ngerprint scanner twice to collect the
ngerprint.
1) Select a ngerprint type.
Note
When the same ngerprints of one person are collected, the prompt with repeat ID appears.
When the similar ngerprints are collected for dierent person, the prompt with repeat ID and
person name appears.
7. Conrm adding the person.
-
Click OK to add the person and close the Add Person window.
-
Click Save and
Connue to add the person and connue to add other persons.
Access Controller User Manual
59