User Manual

Note
If you select Residence mode, you cannot congure person's aendance rule when adding
person.
3. Click OK.
8.1.3 Congure Other Parameters
Aer adding the access control device, you can set its parameters such as network parameters,
capture parameters, RS-485 parameters, Wiegand parameters, etc.
Set Network Parameters
Aer adding the access control device, you can set the device log uploading mode, and create
EHome account via wired or wireless network.
Set Log Uploading Mode
You can set the mode for uploading logs via EHome protocol.
Perform this task when you need to set the access control device's log uploading mode.
Steps
1. Click Access Control → Device Management to enter the Device Management page.
2. Select the device in the device list and click Modify.
3. Click Network
Sengs → Uploading Mode to enter the Uploading Mode page.
4. Select the center group from the drop-down list.
5. Check Enable to enable to set the oploading mode.
6. Select the uploading mode from the drop-down list.
-
Enable N1 or G1 for the main channel and the backup channel.
-
Select Close to disable the main channel or the backup channel
Note
• The main channel and the backup channel cannot enable N1 or G1 at the same
me.
• N1 refers to wired network and G1 refers to GPRS.
• Only device with 3G/4G
funcon supports seng the channel as G1.
• For wired network sengs, see Create EHome Account in Wire Communicaon Mode .
• For wireless network
sengs, see Create EHome Account in Wireless Communicaon Mode .
7. Click Save.
Access Controller User Manual
51