User Manual

If you set 0 as the adding mode, this eld is not required; if you set 2 as the adding mode,
input the device ID registered on the IP Server; if you set 3 as the adding mode, input the
device domain name registered on HiDDNS server; if you set 4 as the adding mode, input the
EHome account; if you set 6 as the adding mode, input the device serial No.
User Name
Input the device user name. By default, the user name is admin.
Password
Input the device password.
Cauon
The password strength of the device can be automacally checked. We highly recommend you
change the password of your own choosing (using a minimum of 8 characters, including at
least three kinds of following categories: upper case leers, lower case leers, numbers, and
special characters) in order to increase the security of your product. And we recommend you
reset your password regularly, especially in the high security system, reseng the password
monthly or weekly can
beer protect your product.
Proper conguraon of all passwords and other security sengs is the responsibility of the
installer and/or end-user.
Add Oine Device
You can input 1 to enable adding the
oine device, and then the soware will automacally
connect it when the oine device comes online. 0 indicates disabling this funcon.
Export to Group
You can input 1 to create a group by the device name (nickname). All the channels of the
device will be imported to the corresponding group by default. 0 indicates disabling this
funcon.
Channel Number
If you set 1 for Add Oine Device, input the channel number of the device. If you set 0 for Add
Oine Device, this eld is not required.
Alarm Input Number
If you set 1 for Add Oine Device, input the alarm input number of the device. If you set 0 for
Add Oine Device, this eld is not required.
Serial Port No.
If you set 5 as the adding mode, input the serial port No. for the access control device.
Baud Rate
If you set 5 as the adding mode, input the baud rate of the access control device.
DIP
Access Controller User Manual
49