User Manual

7.
Oponal: Check Export to Group to create a group by the device name.
8. Oponal: Add the oine devices.
1) Check Add Oine Device.
2) Input the required informaon, including the device channel number and alarm input
number.
3) Click Add.
Note
When the oine device comes online, the soware will connect it automacally.
9. Click Add to add the device.
Import Devices in a Batch
The devices can be added to the soware in batch by inpung the device informaon in the pre-
dened CSV le.
Perform this task to import devices in a batch.
Steps
1. Enter the Device Management page
2. Click Device → Hikvision Device → Add to open the adding device window.
3. Select Batch Import as the adding mode.
4. Click Export Template and then save the
pre-dened template (CSV le) on your PC.
5. Open the exported template
le and input the required informaon of the devices to be added
on the corresponding column.
Adding Mode
You can input 0, 2, 3, 4, 5, or 6 which indicated
dierent adding modes. 0 indicates that the
device is added by IP address or domain name; 2 indicates that the device is added via IP
server; 3 indicates that the device is added via HiDDNS; 4 indicates that the device is added via
EHome protocol; 5 indicates that the device is added by serial port; 6 indicates that the device
is added via Cloud P2P.
Address
Edit the address of the device. If you set 0 as the adding mode, you should input the IP
address or domain name of the device; if you set 2 as the adding mode, you should input the
IP address of the PC that installs the IP Server; if you set 3 as the adding mode, you should
input www.hik-online.com.
Port
Input the device port No. The default value is 8000.
Device
Informaon
Access Controller User Manual
48