User Manual

2. Click Device tab and select Hikvision Device as the device type to display the Online Device
area.
Figure 8-1 Online Device
3. Select an online device from the Online Device area.
Note
For the inacve device, you need to create the password for it before you can add the device
properly. For detailed steps, refer to Acvaon .
4. Click Add to Client to open the device adding window.
5. Input the required informaon.
Address
Input the device's IP address. The IP address of the device is obtained automacally in this
adding mode.
Port
The default value is 8000.
User Name
By default, the user name is admin.
Password
Input the device password.
Cauon
The password strength of the device can be automacally checked. We highly recommend
you change the password of your own choosing (using a minimum of 8 characters, including
at least three kinds of following categories: upper case leers, lower case leers, numbers,
and special characters) in order to increase the security of your product. And we recommend
you reset your password regularly, especially in the high security system, reseng the
password monthly or weekly can
beer protect your product.
Proper conguraon of all passwords and other security sengs is the responsibility of the
installer and/or end-user.
6. Oponal: Check Synchronize Device Time to synchronize the device me with the PC running
the client
aer adding the device to the client.
7. Oponal: Check Export to Group to create a group by the device name.
Access Controller User Manual
42