User Manual

Note
• The Alarm input hardware interface is normally open by default. So only the normally open
signal is allowed. It can be linked to the buzzer of the card reader and access controller, and the
alarm relay output and door relay open and close.
• Arming region alarm input linkage is only for the alarm relay output linkage.
• RS-485 card ID should be set as 1to 8.
Door No. RS-485 Card Reader ID Descripon
Door 1 1 Enter
2 Exit
Door 2 3 Enter
4 Exit
Door 3 5 Enter
6 Exit
Door4 7 Enter
8 Exit
• For four-door access controller, the Wiegand card reader and door's relaonship is as follows.
Door No.
Wiegand Card Reader Descripon
Door 1 1 Enter
/ Exit
Door 2 2 Enter
/ Exit
Door 3 3 Enter
/ Exit
Door 4 4 Enter
/ Exit
Access Controller User Manual
22