User Manual

6. Click Save.
Congure Cross-Device Linkage for Card Swiping
When person swipes the specied card on the specied card reader, it can trigger linkage acons
of other access control device, such as alarm output, opening door, etc.
Perform this task when you need to
congure other access control device's linkage acons for card
swiping.
Steps
1. Click Event Management → Cross-Device Linkage to enter the cross-device linkage
conguraon interface.
2. Click Add to add a new cross-device linkage.
3. Select the linkage type as Card Linkage.
4. Set the event source.
1) Select the card from the dropdown list.
2) Select the access control device as event source device.
3) Select the card reader for triggering.
5. Set the target access control device as linkage target.
1) Select the access control device from the dropdown list as the linkage target.
2) Set the switch to on to enable the linkage
acon.
Alarm Output
The alarm output pf the target device will be triggered for nocaon.
Access Control Point
The door status of open, close, remain open, and remain close will be triggered.
Note
The door status of open, close, remain open, and remain close cannot be triggered at the
same me.
6. Click Save.
Congure
Cross-Device Linkage for Employee ID
When person enter the employee ID on the specied card reader, it can trigger linkage acons of
other access control device, such as alarm output, opening door, etc.
Perform this task when you need to
congure other access control device's linkage acons for
entering employee ID.
Steps
1. Click Event Management → Cross-Device Linkage to enter the cross-device linkage
conguraon interface.
2. Click Add to add a new cross-device linkage.
Access Controller User Manual
97