User Manual

Congure Cross-Device Linkage for Access Control Event
When the access control event is triggered and detected, it can trigger linkage acons of other
access control device, such as alarm output, opening door, etc. The event can be divided into four
types: device event, alarm input, door event, and card reader event.
Perform this task when you need to
congure other access control device's linkage acons for
access control event.
Steps
Note
The devices should support this funcon.
1. Click Event Management → Cross-Device Linkage to enter the cross-device linkage
conguraon interface.
2. Click Add to add a new cross-device linkage.
3. Select the linkage type as Event Linkage.
4. Set the event source.
1) Select the access control device as event source device.
2) Select the access control event type.
Device Event
Select the detailed event type from the dropdown list.
Alarm Input
Select the detailed event type as zone event or alarm input event and select the zone
name or alarm input name from the dropdown list.
Door Event
Select the detailed event type and select the access control point from the dropdown list.
Card Reader Event
Select the detailed event type and select the card reader from the dropdown list.
5. Set the target access control device as linkage target.
1) Select the access control device from the dropdown list as the linkage target.
2) Set the switch to on to enable the linkage
acon.
Alarm Output
The alarm output pf the target device will be triggered for nocaon.
Access Control Point
The door status of open, close, remain open, and remain close will be triggered.
Note
The door status of open, close, remain open, and remain close cannot be triggered at the
same me.
Access Controller User Manual
96