User Manual

Steps
1. Click Event Management → Event Card Linkage to enter the Event Card Linkage page.
2. Select an access control device from the list on the
le.
3. Click Add to add a new linkage.
4.
Select the event source as Employee ID Linkage.
5. Select an employee ID from the drop-down list.
6. In the Linkage Target panel, set the property switch to On to enable the linkage
acon.
Host Buzzer
The audible warning of access control device will be triggered.
Capture
The real-me capture will be triggered.
Alarm Output
The alarm output will be triggered for nocaon.
Access Control Point
The door status of open, close, remain open, and remain close will be triggered.
Note
The door status of open, close, remain open, and remain close cannot be triggered at the
same me.
7. Click Save.
When the employee ID has entered on the selected card reader, it can trigger the linked acons
(congured
in step 7).
8. Aer adding the device linkage, you can do one or more of the following:
Delete Linkage
Sengs
Select the congured linkage sengs in the device list and click Delete
to delete it.
Edit Linkage
Sengs
Select the congured linkage sengs in the device list and you can edit
its event source parameters, including event source and linkage target.
Congure Cross-Device Linkage
You can assign to trigger other access control device's acon by seng up a rule when the access
control event is triggered.
Note
It should be supported by the device.
Access Controller User Manual
95