User Manual

Note
• The door status of open, close, remain open, and remain close cannot be triggered at the
same me.
• The target door and the source door cannot be the same one.
Audio Play
The audio prompt will be triggered. And the select audio index related audio content will be
played according to the
congured play mode.
7. Click Save.
8.
Oponal: Aer adding the device linkage, you can do one or more of the following:
Edit Linkage
Sengs
Select the congured linkage sengs in the device list and you can edit
its event source parameters, including event source and linkage target.
Delete Linkage
Sengs
Select the congured linkage sengs in the device list and click Delete
to delete it.
Congure Device Linked Acons for Card Swiping
You can set the access control device's linkage acons for the specied card swiping. When you
swipe the specied card, it can trigger the alarm output, host buzzer, and other acons on the
same device.
Perform this task when you need to
congure the access control device linkage for the card
swiping acon.
Steps
Note
It should be supported by the device.
1. Click Event Management → Event Card Linkage .
2. Select the access control device from the list on the
le.
3. Click Add buon to add a new linkage.
4. Select the event source as Card Linkage.
5. Input the card number or select the card from the dropdown list.
6. Select the card reader where the card swipes to trigger the linked
acons.
7. In the Linkage Target panel, set the property switch to on to enable this acon.
Host Buzzer
The audible warning of access control device will be triggered.
Capture
The real-me capture will be triggered.
Recording
Access Controller User Manual
93