User Manual

Congure Device Linkage for Access Control Alarm
You can set the access control device's linkage acons for the access control device's triggered
alarm. When the alarm is triggered, it can trigger the alarm output, host buzzer, and other
acons
on the same device.
Perform this task when you need to congure the access control device linkage for the device's
access control alarm.
Steps
Note
It should be supported by the device.
1. Click Event Management → Event Card Linkage .
2. Select the access control device from the list on the le.
3. Click Add buon to add a new linkage.
4. Select the event source as Event Linkage.
5. select the alarm type and detailed alarm to set the linkage.
6. In the Linkage Target panel, set the property switch to on to enable this
acon.
Host Buzzer
The audible warning of access control device will be triggered.
Capture
The real-me capture will be triggered.
Recording
The recording will be triggered.
Note
The device should support recording.
Card Reader Buzzer
The audible warning of card reader will be triggered.
Alarm Output
The alarm output will be triggered for nocaon.
Zone
Arm or disarm the zone.
Note
The device should support zone funcon.
Access Control Point
The door status of open, close, remain open, and remain close will be triggered.
Access Controller User Manual
92