User Manual

Table Of Contents
3) Click OK.
Aer selecng the modes, the selected modes will display as icons with dierent color.
4. Click the icon to select a card reader
authencaon mode, and drag the cursor to draw a color
bar on the schedule, which means in that period of me, the card reader authencaon is valid.
5. Repeat the above step to set other me periods.
Figure 9-13 Set Authencaon Modes for Card Readers
6. Oponal: Select a congured day and click Copy to Week to copy the same sengs to the
whole week.
7.
Oponal: Click Copy to to copy the sengs to other card readers.
8. Click Save.
9.7.5
Congure First Person In
You can set mulple rst persons for one access control point. Aer the rst person is authorized,
it allows
mulple persons access the door or other authencaon acons.
Before You Start
Set the access group and apply the access group to the access control device. For details, refer to
Set Access Group to Assign Access
Authorizaon to Persons .
Perform this task when you want to
congure opening door with rst person.
Steps
1. Click Access Control → Advanced Funcon → First Person In to enter the First Person In page.
2. Select an access control device in the list on the le panel.
3. Select the current mode as Enable Remaining Open
aer First Person or Disable Remaining
Open aer First Person from the drop-down list for each access control point of the selected
device.
Enable Remaining Open
aer First Person
DS-K1TA70 Series Face Recognion Terminal User Manual
135