User Manual

Open Timeout Alarm (Door Open Timeout Alarm)
An alarm will be triggered if the door has not been closed within the congured me duraon.
8.5.16 Set Card Security
Click Conguraon → Access Control → Card Security to enter the sengs page.
Set the parameters and click Save.
Enable NFC Card
In order to prevent the mobile phone from
geng the data of the access control, you can
enable NFC card to increase the security level of the data.
Enable M1 Card
Enable M1 card to authencate by presenng M1 card.
Enable EM Card
Enable EM card to authencate by presenng EM card.
Enable CPU Card
The device can read the data from CPU card when enabling the CPU card funcon.
Enable ID Card
Enable ID card to authencate by presenng ID card.
8.5.17
Congure SIP Parameters
Set the main staon's IP address and the SIP server's IP address. Aer seng the parameters, you
can communicate among the access control device, door staon, indoor staon, main staon, and
the
plaorm.
Note
Only the access control device and other devices or systems (such as door staon, indoor staon,
main staon, plaorm) are in the same IP segment, the two-way audio can be performed.
Go to Conguraon → Access Control → Group → Linked Network Sengs .
Set the main staon's IP address and SIP server's IP address.
Click Save.
8.5.18 Set RS-485 Parameters
You can set the RS-485 parameters including the peripheral, address, baud rate and output type.
Click
Conguraon → Access Control → RS-485 Sengs .
Click Save to save the sengs aer the conguraon.
DS-K1T680 Series Face Recognion Terminal User Manual
76