User Manual

Note
Up to four aerward card readers can be added for one card reader.
6. Click OK in the dialog to save the
selecons.
7. Click Save at the upper-right corner of
An-Passback page to save the sengs and take eect.
Note
Super credenals, such as super card, super password, super ngerprint, and so on, have the
privilege of not following the an-passback rules.
Example
Set Card Swiping Path
If you select Reader In_01 as the beginning, and select Reader In_02, Reader Out_04 as the linked
card readers. Then you can only get through the access control point by swiping the card in the
order as Reader In_01, Reader In_02 and Reader Out_04.
9.7.7
Congure Mul-door Interlocking
You can set the mul-door interlocking between mulple doors of the same access control device.
To open one of the doors, other doors must keep closed. That means in the interlocking combined
door group, up to one door can be opened at the same
me.
Before You Start
Add access control device to the client, and make sure the device supports the mul-door
interlocking funcon.
Steps
Note
•
Mul-door Interlocking funcon is only supported by the access control device which has more
than one access control points (doors).
• Either the an-passing back or mul-door interlocking funcon can be congured for an access
control device at the same me. For the conguraon of an-passing back funcon, refer to
Congure An-Passback .
1. Click Access Control → Advanced Funcon → Mul-door Interlocking .
2. Select an access control device on the le panel.
3. Click Add on the
Mul-door Interlocking List panel to open Add Access Control Point to open
the Add window.
4. Select at least two access control points(doors) from the list.
Note
Up to four doors can be added in one mul-door interlocking combinaon.
DS-K1T680 Series Face Recognion Terminal User Manual
124