User Manual

Steps
1. Click
Conguraon → Network → Advanced → Plaorm Access to enter the sengs page.
2. Check the checkbox of Enable to enable the
funcon.
3. Select the Plaorm Access Mode.
Note
Hik-Connect is an applicaon for mobile devices. With the App, you can view live image of the
device, receive alarm nocaon and so on.
4.
Create a Stream Encrypon/Encrypon Key for the device.
Note
6 to 12 leers (a to z, A to Z) or numbers (0 to 9), case sensive. You are recommended to use a
combinaon of no less than 8 leers or numbers.
5. Click Save to enable the sengs.
Set ISUP Parameters
Set the ISUP parameters for accessing device via ISUP protocol.
Steps
Note
The funcon should be supported by the device.
1. Click Conguraon → Network → Advanced Sengs → Plaorm .
2. Select ISUP from the plaorm access mode drop-down list.
3. Check Enable.
4. Set the ISUP version, server address, device ID, and the ISUP status.
Note
If you select 5.0 as the version, you should set the ISUP key as well.
5. Click Save.
Congure
HTTP Listening
The device can send alarm informaon to the desnaon IP or host via HTTP protocol.
Before You Start
The desnaon IP or host name should support the HTTP protocol to receive the alarm
informaon.
Face Recognion Terminal User Manual
73