User Manual

Max. Speaking Duraon with Access Control Device
Specify the seconds that the call with access control device will last for at most. The
maximum speaking duraon between access control device and the client can be set from
90s to 120s.
4. Click Save.
9.12.5 Set File Saving Path
The pictures captured in Status Monitoring module are stored on the local PC. The saving path of
these
les can be set.
Steps
1. Open the System Conguraon page.
2. Click File tab to enter the File Saving Path Sengs page.
3. Click
and select a local path for the les.
4. Click Save.
9.12.6 Set Email Parameters
When an event is triggered, if you can set Send Email as linkage acon for this event, the client will
an email to the recipients for nocaon. You need to set the email sengs and specify target
recipients in this
secon.
Steps
1. Enter the System
Conguraon module.
2. Click Email tab to enter the Email Sengs interface.
3. Enter the required
informaon.
STMP Server
The STMP server IP address of host name (e.g., smtp.263xmail.com)
Encrypon Type
You can check the radio to select Non-Encrypted, SSL, or STARTTLS .
Port
Enter the communicaon port used for SMTP. The port is 25 by default.
Sender Address
The email address of the sender.
Security Cercate (Oponal)
If your email server requires authencaon, check this checkbox to use authencaon to log
into the server and enter the login user name and password of your email account.
User Name
Face Recognion Terminal User Manual
182