User Manual

Congure Break Time
You can add break me and set start me, end me, duraon, calculaon mode and other
parameters for the break. The added break
me can also be edited or deleted.
Steps
1. Click Time &
Aendance → Timetable → Break Time .
The added break me is displayed in the list.
2.
Click Break Time Sengs to enter Break Time Sengs window.
3. Click Add.
4. Enter a name for the break
me.
5. Set related parameters for the break me.
Start Time / End Time
Set the me when the break starts and ends.
No Earlier Than / No Later Than
Set the earliest swiping me for starng break and the latest swiping me for ending break.
Break Duraon
The duraon from start me to end me of the break.
Calculaon
Auto Deduct
The break duraon will be automacally calculated as 60 minutes.
Must Check
The break duraon will be calculated and excluded from work hours according to actual
check-in and check-out
me.
Return from Break Early for
The actual check-in and check-out me does not exceed the break me, and can be
marked as normal work or work
overme.
Return from Break Late for
The actual check-in and check-out me exceeds the break me, and can be marked as
late, absent or early leave.
Calculated by
Each Check in/out: Each check-in me and check-out me is valid and the sum of all
periods between adjacent check-in and check-out
me will be recorded as the break
me duraon.
First In & Last Out: The rst check-in me is recorded as start break me and the last
check-out me is recorded as the end break me.
Enable T&A Status
Face Recognion Terminal User Manual
163