User Manual

Open Duraon
Aer swiping the normal card and relay acon, the mer for locking the door starts working.
Super Password
The specic person can open the door by inpung the super password.
Door Le Open Timeout Alarm
The alarm can be triggered if the door has not been closed in a congured me period. If it is
set as 0, no alarm will be triggered.
Click Advanced to
congure more parameters.
Extended Open Duraon
The door contact can be enabled with appropriate delay aer person with extended accesss
needs swipes her/his card.
Duress Code
The door can open by inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Note
• The duress code and the super code should be
dierent.
• The duress code and super password should be dierent from the authencaon password.
• The length of duress code and the super password is according to the device, usually it should
contains 4 to 8 digits.
5. Click OK.
6.
Oponal: Click Copy to , and then select the door/oor(s) to copy the parameters in the page to
the selected doors/oor(s).
Note
The door's status duraon sengs will be copied to the selected doors as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card reader parameters.
Steps
1. Click Access Control → Advanced Funcon → Device Parameter .
2. In the device list on the le, click to expand the door, select a card reader and you can edit
the card reader's parameters on the right.
3. Edit the card reader basic parameters in the Basic
Informaon page.
Face Recognion Terminal User Manual
129