User Manual

If enable the funcon, the device can recognize the NFC card. You can present NFC card on
the device.
Enable M1 Card
If enable the funcon, the device can recognize the M1 card. You can present M1 card on the
device.
Enable EM Card
If enable the funcon, the device can recognize the EM card. You can present EM card on the
device.
Note
If the peripheral card reader supports presenng EM card, the funcon is also supported to
enable/disable the EM card funcon.
4. Click OK.
5. Oponal: Click Copy to, and then select the access control device(s) to copy the parameters in
the page to the selected device(s).
Congure
Parameters for Door
Aer adding the access control device, you can congure its access point door parameters.
Steps
1. Click Access Control → Advanced
Funcon → Device Parameter .
2. Select an access control device on the le panel, and then click to show the doors of the
selected device.
3. Select a door to show its parameters on the right page.
4. Edit the door parameters.
Note
The displayed parameters may vary for dierent access control devices.
•
• Some of the following parameters are not listed in the Basic
Informaon page, click Advanced
to edit the parameters.
Name
Edit the card reader name as desired.
Door Contact
You can set the door sensor as remaining closed or remaining open. Usually, it is remaining
closed.
Exit Buon Type
You can set the exit buon as remaining closed or remaining open. Usually, it is remaining
open.
Face Recognion Terminal User Manual
128