User Manual

7.11.4 Call Room from Device
Steps
1. Get the client
soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client
soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the indoor
staon and the device to the client soware.
Note
For details about adding device, see Add Device.
5. Link a user to an indoor staon and set a room No. for the indoor staon.
6. Call the room.
-
If you have
congured a specied room No. in the Basic Sengs , you can tap to call the
room.
-
If you have not congured a specied room No. in the Basic Sengs , you should tap on
the authencaon page of the device. Enter the room No. on the dial page and tap to call
the room.
7.
Aer the indoor staon answers the call, you can start two-way audio with the indoor staon.
7.11.5 Call Mobile Client from Device
Steps
1. Get the mobile mobile client from the supplied disk or the
ocial website, and install the
soware according to the prompts.
2. Run the mobile client and add the device to the mobile client.
Note
For details, see the user manual of the mobile client.
3. Enter Basic Sengs → Shortcut Key and enable Call APP.
4. Go back to the inial page and call the mobile client.
1) Tap
on the device inial page.
2) Tap to call the mobile client.
Face Recognion Terminal User Manual
60