Users Manual

6.3.1 Set Network Parameters
You can set the device network parameters, including the IP address, the subnet mask, and the
gateway.
Steps
1. Tap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs
page.
2. On the Communicaon Sengs page, tap Network to enter the Network tab.
Figure 6-5 Network
Sengs
3. Set the device network informaon.
-
If the DHCP funcon is enabled, the system will allocate an IP address, subnet mask, and
g
ateway automacally.
-
If the DHCP funcon is not enabled, you should set the device IP address, subnet mask, and
gateway.
4. Tap OK to save the sengs.
Note
The device's IP address and the computer IP address should be in the same IP segment.
5. T
ap
to save the network parameters.
Face Recognion Terminal User Manual
34