Users Manual

6.3.1 Set Network Parameters

You can set the device network parameters, including the IP address, the subnet mask, and the

gateway.

Steps

1. Tap Comm. (Communicaon Sengs) on the Home page to enter the Communicaon Sengs

page.

2. On the Communicaon Sengs page, tap Network to enter the Network tab.

Figure 6-5 Network

Sengs

3. Set the device network informaon.

If the DHCP funcon is enabled, the system will allocate an IP address, subnet mask, and

ateway automacally.

If the DHCP funcon is not enabled, you should set the device IP address, subnet mask, and

gateway.

4. Tap OK to save the sengs.

Note

The device's IP address and the computer IP address should be in the same IP segment.

5. T

to save the network parameters.

Face Recognion Terminal User Manual