Users Manual

Main Channel
The device will communicate with the center via the main channel.
Note
N1 refers to wired network.
7.12.10 Network Center Parameters Sengs
You can set the nofy surveillance center, center's IP address, the port No., the protocol (EHome),
the EHome acc
ount user name,etc. to transmit data via EHome protocol.
On the Device for Management page, click
→ Network → Ne
twork Center Parameters to enter
the Network Center Parameters Sengs tab.
Select a center from the drop-down list.
Aer enabling the funcon, you can set the center's address type, IP address/domain name, port
No., EHome user name, etc.
Click Save.
7.12.11 Congure Wi-Fi
Steps
1. On the Device for Management page, click
→ Network → Wi-Fi t
o enter the Wi-Fi Sengs
tab.
2. Check Enable t
o enable the Wi-Fi funcon.
3. Enter the SSID name and password or you can select a network from the Wi-Fi list.
4. Set the Wi-Fi Security Mode from the drop-down list.
5. Oponal: Click R
efresh to refresh the network status.
6. Oponal: Set WLAN parameters.
1) On the Wi-Fi Sengs page, click WLAN to enter the WLAN page.
2) Uncheck DHCP and set the IP address, the subnet mask, the default gateway, the MAC
address, the DNS1 IP Address, and the DNS2 IP address.
7. Click Save.
7.12.12 Set Access Control Parameters
Steps
1. On the De
vice for Management page, click
→ Others → Access Con
trol Parameters to enter
the Access Control Parameters tab.
2. Check the checkbox to enable the funcon.
Audio Prompt (Voice Prompt)
Face Recognion Terminal User Manual
147