Users Manual

The maximum transmission unit (MTU) of the network interface.
6. Click Save.
Set Network Parameters
Aer adding the access control device, you can set the device log uploading mode, and create ISUP
acc
ount via wired network.
Set Log Uploading Mode
You can set the mode for the device to upload logs via ISUP protocol.
Steps
Note
Make sure the device is not added by ISUP.
1. En
ter the Access Control module.
2. On the navigaon bar on the le, enter Advanced Funcon → More Parameters .
3. Select an access control device in the device list and enter Network → Uploading Mode .
4. Select the center group from the drop-down list.
5. Check Enable to enable to set the uploading mode.
6. Select the uploading mode from the drop-down list.
-
Enable N1 or G1 for the main channel and the backup channel.
-
Select Close to disable the main channel or the backup channel
Note
The main channel and the backup channel cannot enable N1 or G1 at the same me.
N1 refers to wired network and G1 refers to GPRS.
7. Click Sa
ve.
Create EHome Account in Wired Communicaon Mode
You can set the account for EHome protocol in wired communicaon mode. Then you can add
devices via EHome protocol.
Steps
Note
This funcon should be supported by the device.
Make sure the device is not added by EHome.
1. En
ter the Access Control module.
Face Recognion Terminal User Manual
108