User Manual
Table Of Contents
- Chapter 1 Product Introduction
- Chapter 2 Remote Control Operations
- Chapter 3 Client Software Operation
- Chapter 4 Material Management
- Chapter 5 Program Management
- 5.1 Add Program
- 5.1.2 Configure Program Basic Settings
- 5.1.3 Manage Page
- 5.1.4 Create Picture Program
- 5.1.5 Create PDF Program
- 5.1.6 Create Document Program
- 5.1.7 Create Audio/Video/Live Video Program
- 5.1.8 Create Webpage Program
- 5.1.9 Create Clock Program
- 5.1.10 Create Weather Program
- 5.1.11 Create Countdown Program
- 5.1.12 Create Video Input Program
- 5.1.13 Create Pop-up Image Program
- 5.1.14 Create Queue Manager Program
- 5.1.15 Create Capture Program
- 5.1.16 Create Button Program
- 5.1.17 Create App Program
- 5.1.18 Hyperlink Feature for Android Touchscreen Program
- 5.2 Check Program
- 5.3 Modify Program
- 5.4 Delete Program
- 5.5 Preview Program
- 5.1 Add Program
- Chapter 6 Schedule Management
- Chapter 7 Terminal Management
- 7.1 Adding Terminal
- 7.2 Toolbar
- 7.3 Terminal Remote Configuration
- 7.3.1 Configure Timed Startup/Shutdown
- 7.3.2 Configure Timed Volume
- 7.3.3 Configure Device Input Port Switch
- 7.3.4 Configure Default Volume
- 7.3.5 Configure Backlight
- 7.3.6 Configure Logo
- 7.3.7 Configure Default Schedule
- 7.3.8 Configure Terminal Password
- 7.3.9 Configure Temperature Protection
- 7.3.10 Configure Time Zone
- 7.3.11 Configure Terminal Security
- 7.3.12 Check Additional Component Information
- 7.3.13 Configure Terminal IP Address
- 7.3.14 Configure Linked Server IP Address
- 7.3.15 Adding IP Channel
- 7.4 Modify Terminal
- 7.5 Delete Terminal
- Chapter 8 General Configuration
- Appendix A Operation Flow Chart
- Appendix B Deployment Diagram
- Appendix C Troubleshooting
Information Release System User Manual
8
2.3 Bind a Remote Control to a Terminal
Purpose:
After being bound to the remote control, the terminal cannot be controlled by any other remote
controls and the remote control cannot control any other terminals.
Step 1 Long press key and key on the remote control at the same time until the terminal
pops up the verification code.
The system pops up a box for you to enter the verification code only when your terminals are
unbound to any remote controls.
Step 2 Enter the verification code of the desired terminal.
Step 3 Long press key and key at the same time until the system pops up the success
message.
2.4 Unbind a Remote Control from a Terminal
Purpose:
After being unbound from the remote control, the terminal can be controlled by any unbound
remote controls and the remote control cannot control any unbound terminals.
Long press key and key at the same time until the system pops up the success message.
After you press the keys on the remote control, the terminal may not receive the unbinding
request due to some reasons, such as device power-off or weak signals. In such cases, the remote
control will be unbound from the terminal immediately while the terminal remains bound until it
receives the request.