User Manual

Information Release System User Manual
18
Step 4 Click .
4.2 Check Material
Purpose:
Only checked material can be added to program. Only user has material check permission can
check materials.
4.2.1 Auto Check
Purpose:
If you are a user with check permission, you can enable auto check when uploading material.
Step 1 Click the Upload Materials tab in Material Management interface.
Step 2 Select materials to upload. For detailed steps, refer to:
 Step 1 to 2 of Add Local Material.
 Step 1 to 2 of Add Dynamic Material.
Step 3 Check the Auto Check in lower right corner of Upload Materials interface.
For user without check permission, Auto Check is checked by default and is not configurable.
Step 4 Click . Then system will automatically check the material.
4.2.2 Manual Check in Material List Tab
Step 1 Click the Material List tab in Material Management interface.
Step 2 Select material whose Check Status is To be Approved.
Step 3 Click .
Step 4 Select check Result as Pass or Deny.
Step 5 Enter your check Comment if needed.