User Manual
Table Of Contents
- Legal Information
- Regulatory Information
- Preface
- Chapter 1 Product Introduction
- Chapter 2 Device Activation and Login
- Chapter 3 Client Configuration and Operation
- 3.1 Wizard
- 3.2 Signal Input Type Configuration
- 3.3 Display Adjustment
- 3.4 Volume Adjustment
- 3.5 Configure a Scene
- 3.6 Add Device Alias
- 3.7 Configure Message
- 3.8 Configure OSD
- 3.9 Configure Network
- 3.10 Configure No-Signal Screensaver
- 3.11 Configure On/off Image
- 3.12 Configure Multicast Control
- 3.13 Configure Video Window Opening
- 3.14 Configure Screen Splicing
- Chapter 4 Device Maintenance
- Chapter 5 System Maintenance
- Chapter 6 Local Configuration and Operation
- Chapter 7 FAQ
- 7.1 Full Screen is Unlit
- 7.2 Image is Incomplete or in Wrong Position
- 7.3 Full-screen Image Flashes or Vibrates
- 7.4 Spots/Strips Exist in Full-screen Image
- 7.5 Certain Unit Image Flashes or Has Spots
- 7.6 Certain Unit Screen is Unlit
- 7.7 Certain Module or Row of Modules are Unlit in Unit
- 7.8 Screen Display Error When Smart Settings
- 7.9 Searching Online Device Fail
Port of sending card is applied to communicate between sending card and receiving card. The
receiving card connected by signal sending port is Card1, the receiving card connected to the
rst sending card is Card2, and so on.
Cancel
Cancel last operaon.
Restore
Resume last operaon.
Reset Current Port
Cancel all sengs of current signal sending port.
Reset All Ports
Cancel sengs of all signal sending ports.
Signal Backup
Input signals by two channels to ensure signal stability.
Note
If Signal Backup checked, the relaon between the main and sub ports should be the same as that
of the client.
3.2 Signal Input Type Conguraon
Select the signal source type in the upper right corner of Display Status. You should select the
signal source according to the sending card resoluon.
Note
Dierent signal source may result in dierent resoluon.
3.3 Display Adjustment
Screen can get best display eects by conguring image parameters, brightness and enhancement,
screen display parameters, etc.
3.3.1 Correct Screen/Seam
You can correct screen and seam manually or in a batch to deliver beer LED display eects.
Correct Screen Manually
Correct display parameters of LED screens to achieve the same display eects.
Full-Color LED Display Controller User Manual
10