User Manual

DS-7700NI-SP/9000/9600 Series HDVR/NVR User’s Manual
132
Figure 155 Group Mode Settings Menu
4. Click the Apply button to pop up an attention box as shown below:
Figure 156 Attention for reboot
5. Click Yes to reboot and make the settings effective. Click No to cancel the operation.
6. After rebooting, you can configure local HDD settings. To configure local HDD settings by going
to Menu > System Configuration > HDD > HDD Information.
1) Select a HDD and click to pop up the Local HDD Settings menu as shown in Figure
157.
Figure 157 Local HDD Settings
2) Select the HDD Property from R/W, Read-only and Redundancy. Read-only mode can
prevent important recorded files from being overwritten when the HDD becomes full in
overwrite recording mode. Redundancy mode can ensure high security and reliability by
recording the video onto the redundancy HDD and R/W HDD simultaneously.
3) Select the Group number for the current HDD. The default group number for each HDD is 1.
4) Click the Apply button to save the settings and click OK to the up level menu.
Note: