User's Manual
Table Of Contents
- Chapter 1 Introduction
- Chapter 2 Getting Started
- Chapter 3 Camera Management
- Chapter 4 Camera Settings
- Chapter 5 Live View
- Chapter 6 PTZ Control
- Chapter 7 Storage
- 7.1 Storage Device Management
- 7.2 Storage Mode
- 7.3 Recording Parameters
- 7.4 Configure Recording Schedule
- 7.5 Configure Continuous Recording
- 7.6 Configure Motion Detection Triggered Recording
- 7.7 Configure Event Triggered Recording
- 7.8 Configure Alarm Triggered Recording
- 7.9 Configure Picture Capture
- 7.10 Configure Holiday Recording and Capture
- 7.11 Configure Redundant Recording and Capture
- Chapter 8 Disk Array
- Chapter 9 File Management
- Chapter 10 Playback
- Chapter 11 Event and Alarm Settings
- 11.1 Configure Arming Schedule
- 11.2 Configure Alarm Linkage Actions
- 11.3 The alarm signal will be transmitted automatically at detection mode when remote alarm host is configured. Please refer to Chapter 14.8 Configuring NAT
- 11.4 Configure Motion Detection Alarm
- 11.5 Configure Video Loss Alarm
- 11.6 Configure Video Tampering Alarm
- 11.7 Configure Sensor Alarms
- 11.8 Configure Exceptions Alarm
- 11.9 Alarm Linkage Actions
- 11.10 Trigger or Clear Alarm Output Manually
- Chapter 12 VCA Event Alarm
- 12.1 Face Detection
- 12.2 Vehicle Detection
- 12.3 Line Crossing Detection
- 12.4 Intrusion Detection
- 12.5 Region Entrance Detection
- 12.6 Region Exiting Detection
- 12.7 Unattended Baggage Detection
- 12.8 Object Removal Detection
- 12.9 Audio Exception Detection
- 12.10 Sudden Scene Change Detection
- 12.11 Defocus Detection
- 12.12 PIR Alarm
- 12.13 Thermal Camera Detection
- 12.14 Queue Management
- Chapter 13 Smart Analysis
- Chapter 14 Network Settings
- Chapter 15 Hot Spare Device Backup
- Chapter 16 System Maintenance
- Chapter 17 General System Settings
- Chapter 18 Appendix
Network Video Recorder User Manual
30
Enter the password to activate the IP camera (s) connected to the device.
Optionally, check Export GUID to export the GUID for future password
resetting.
Click OK to save the password and activate the device.
After the device is activated, you should properly keep the password.
When you have enabled Export GUID, continue to export the GUID file to the USB flash driver
for the future password resetting.
You can duplicate the password to the IP cameras that are connected with default protocol.
Configure Unlock Pattern for Login.
Right click the mouse on the screen and select the menu to enter the interface.
Draw the Unlock Pattern
Draw the pre-defined pattern to unlock to enter the menu operation.