Quick Start Guide

Network Video Recorder Quick Start Guide
10
Chapter 2 Installation and Connections
2.1 Installation
During installation of the NVR:
● Use brackets for rack mounting.
● Ensure ample room for audio and video cables.
● When routing cables, ensure that the bend radius of the cables are no less than five times than
its diameter.
● Connect the alarm cable.
● Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
● Ensure the NVR is grounded.
● Environmental temperature should be within the range of -10° C to +55° C (+14° F to +131° F).
● Environmental humidity should be within the range of 10% to 90%.
2.2 Hard Disk Installation
Before you start:
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory
recommended HDD should be used for this installation.
Tools Required: Screwdriver.
2.2.1 DS-96000NI-I16(/H) Series
Purpose:
The following section introduces the HDD installation for the DS-96000NI-I16(/H) series NVR.
Step 1 Fasten the hard disk mounting handle to the hard disk with screws.
Figure 2-1 Fasten Hard Disk
Step 2 Insert the key and turn in clockwise direction to open the panel lock.