Operation Manual

Using electromagnetic detection
The door transmitter can be set to detect electromagnetic elds emitted
by electromechanical doorbells. You only need to use this function if the
programming of the door transmitter has failed. Here is how it’s done:
Activating electromagnetic detection
Move the 4th signal-switch to the
Up=On position.
Deactivating electromagnetic
detection
Move the 4th signal-switch to the
Down=O position.
Clear the recorded sounds
To clear all recorded sounds, press and hold button 1 and 2 simultaneously for 5s.
Please note: This will clear the sounds that has been recorded during programming.
All radio key settings and transmitted signal settings will be kept intact.
1
1
Customizing the signal
The door transmitter controls the signal pattern on
the receiver. To customize the signal pattern, move
the signal switches according to the tables on
the following spreads.
Switch no. 4 is for electromagnetic detection.
A
On
O
A
Changing the radio key
If you install multiple systems, you can set a
unique radio key for each system to avoid radio
interference. Move any radio key switch to
the up=on position to change the radio key.
Please note
All Visit products within the same system must be set
to the same radio key in order to operate as a group.
On
O
B
B
On
O
85 86