Operation Manual
Grön: OK
Röd: Ej OK
Green: OK
Red: Not OK
Programming
You can teach the door transmitter to recognize the sound of your doorbell.
1 Press and hold button 1 until the LED blinks. Release it to start the recording.
2 Ring the doorbell 5 times (pause between each press). The recording lasts for
5 min and ends automatically. Press button 1 to stop it manually.
3 When it’s nished, the LED stops blinking. If the LED is red, see Trouble
shooting. Record the intercom with button 2 by repeating steps 1-2 above.
Grön: OK
Röd: Ej OK
2
31
Using the External microphone
Connect the External microphone accessory to the microphone socket
(see Overview). The External microphone is used in the following scenarios:
1 When the sound source is located too far away from the internal microphone
2 When you need individual notications from eg. the doorbell and intercom
The default signal pattern on the receiver is as follows:
Triggered microphone Light Vibration Sound
Internal microphone
Green light Slow pattern 1 x ding dong, Lo
External microphone
Blinking in green Slow pattern 2 x ding dong, Hi
You can easily customize the receiver’s signal pattern by moving the signal
switches on the door transmitter according to the tables on page 87-90.
Please note: Do not place the External microphone too close to the door trans-
mitter. This might cause interference.
83 84