User Manual

UM DS-90xxHUHI-F8/N User Manual 041717NA 54

960 × 1080 (1080p Lite) resolution is available when the 1080p Lite is

enabled in the Record > Advanced Settings interface.

7. Bitrate Type: Set the bitrate type to be Variable or Constant.

8. Video Quality: Set the video quality of recording, with 6 levels configurable.

NOTE: The Stream Type, Resolution, Bitrate Type, and Video Quality are not

configurable for the Main Stream (Event) of the IP Camera.

9. Frame Rate: Set the frame rate of recording.

0. Max. Bitrate Mode: Set the mode to General or Custom.

11. Max Bitrate (Kbps): Select or customize the maximum bit rate for recording.

12. Max. Bitrate Range Recommended: A recommended max. bit rate range is provided for

reference.

13. Max. Average Bitrate (Kbps): Set the max. average bit rate which refers to the average amount

of data transferred per unit of time.

NOTE: When the connected IP camera does not support H.265, only H.264

can be selected for the video encoding.

14. Check the Enable H.264+ or Enable H.265+ checkbox to enable this function. Enabling it helps

to ensure the high video quality with a lower bitrate.

NOTE: If the connected IP camera supports H.265 and H.265 is enabled,

Enable H.265+ is shown on the interface instead of Enable H.264+.

After enabling H.264+ or H.265+, the Bitrate Type, Video Quality, Max.

Bitrate Mode, Max. Bitrate (Kbps), and Max. Bitrate Range

Recommend are not configurable.

H.264+ or H.265+ are not supported simultaneously with SVC.

For the connnected IP camera, H.264+ or H.265+ should be

supported by the camera and added to the DVR with the HIKVISION

protocol.

Reboot the device to activate the new settings after enabling H.264+

or H.265+.

15. Click More Settings to configure more parameters.