User Manual

UM DS-90xxHUHI-F8/N User Manual 041717NA 35
9.1.2. View
This section explains how to assign cameras to Live View screen positions.
Figure 40, Live View View Settings
1. Go to MENU > SYSTEM CONFIGURATION > LIVE VIEW > VIEW.
2. Use pull-down menu to select the Video Output Interface you want to configure.
3. Click on a screen layout (directly beneath screen po
sitions) that you want the monitor to have.
4. Highlight a screen position on the top right section of the screen.
5. Double click a camera on the camera list on the left of the screen to assign the camera to the
highlighted screen position.
6. Repeat for all screen positions.
7. Press the Apply button.
9.1.3. Channel-Zero Encoding
Channel-Zero Encoding combines all video streams into one lower resolution, lower bandwidth
channel. Do the following to enable Channel-Zero Encoding:
1. Go to MENU > SYSTEM CONFIGURATION > LIVE VIEW > CHANNEL-ZERO ENCODING.
2. Check the Enable Channel-Zero Encoding checkbox.
3. Use the pull-down menu to select the channel frame rate.
4. Use the pull-down menu to select the M
ax.(imum) Bitrate Mode.
5. Use the pull-down menu to select the Max.(imum) Bitrate in Kbps.
6. Press the Apply button.