Quick Start Guide

Network Video Recorder Quick Start Guide
19
Chapter 2 Installation and Connections
2.1 Installation
During installation of the NVR:
 Use brackets for rack mounting.
 Ensure ample room for audio and video cables.
 When routing cables, ensure that the bend radius of the cables are no less than five times than
its diameter.
 Connect the alarm cable.
 Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
 Ensure the NVR is grounded.
 Environmental temperature should be within the range of -10° to +55° C (+14° to +131° F).
 Environmental humidity should be within the range of 10% to 90%.
2.2 Hard Disk Installation
Before You Start
Disconnect the power from the NVR before installing a hard disk drive (HDD). A factory
recommended HDD should be used for this installation.
Tools Required: Screwdriver.
2.2.1 Front Panel Plug-Pull Installation
Front panel plug-pull installation is applicable when you need to open the device front panel with
key and install the HDD.
Step 1 Fix mounting ears to HDD with screws.
Figure 2-1 Fix Mounting Ears to HDD