Quick Start Guide
DS-76xxNI-QxxP NVR Quick Start Guide 
QSG DS-76xxNI-QxxP 062618NA  4 
Safety Instructions 
•  Proper configuration of all passwords and other security settings is the responsibility of the installer 
and/or end-user. 
•  In the use of the product, you must be in strict compliance with the electrical safety regulations of 
the nation and region. Please refer to technical specifications for detailed information. 
•  Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power Source 
with 100~240 VAC or 12 VDC according to the IEC60950-1 standard. Please refer to technical 
specifications for detailed information. 
•  Do not connect several devices to one power adapter as adapter overload may cause over-heating 
or a fire hazard. 
•  Please make sure that the plug is firmly connected to the power socket. 
•  If smoke, odor or noise rise from the device, turn off the power at once and unplug the power cable, 
and then please contact the service center. 
•  If the POE ports of device do not comply with Limited Power Source, the additional equipment 
connected to POE ports shall have fire enclosure. 
•  The USB interface of the /P devices can be connected with the mouse and U-flash disk storage 
device only. 
Preventive and Cautionary Tips 
Before connecting and operating your device, please be advised of the following tips: 
•  Ensure unit is installed in a well-ventilated, dust-free environment. 
•  Unit is designed for indoor use only. 
•  Keep all liquids away from the device. 
•  Ensure environmental conditions meet factory specifications. 
•  Ensure unit is properly secured to a rack or shelf. Major shocks or jolts to the unit as a result of 
dropping it may cause damage to the sensitive electronics within the unit. 
•  Use the device in conjunction with an UPS if possible. 
•  Power down the unit before connecting and disconnecting accessories and peripherals. 
•  A factory recommended HDD should be used for this device. 
•  Improper use or replacement of the battery may result in hazard of explosion. Replace with the same 
or equivalent type only. Dispose of used batteries according to the instructions provided by the 
battery manufacturer. 










